Netopia 4522 Manual Do Utilizador
6-8 Getting Started Guide
Routed 1483. If you select Bridged 1483, a new option PPP over Ethernet (PPPoE) appears. You can
then toggle PPPoE On or Off. Choosing Routed 1483 hides the PPPoE option.
then toggle PPPoE On or Off. Choosing Routed 1483 hides the PPPoE option.
■
If you selected ATM Operation Mode in Step 1, the Data Circuit VPI and VCI fields become visible.
These are editable fields. The default values 0 and 35 are typical for ADSL circuits, so you will only
need to change them if your ser vice provider explicitly tells you to do so.
These are editable fields. The default values 0 and 35 are typical for ADSL circuits, so you will only
need to change them if your ser vice provider explicitly tells you to do so.
9.
Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.
Easy Setup Profile
The Easy Setup Profile screen is where you configure the parameters that control the Netopia 4522’s
connection to a specific remote destination, usually your ISP or a corporate site.
connection to a specific remote destination, usually your ISP or a corporate site.
On a Netopia 4522 you can add up to 15 more connection profiles, for a total of 16, although you can only use
one at a time, unless you are using Vir tual Private Networks (VPNs).
one at a time, unless you are using Vir tual Private Networks (VPNs).
Note:
The appearance of this screen varies, depending on the settings in the previous screen.
1.
To enable address translation, toggle Address Translation Enabled to Yes (the default). For more
information on Network Address Translation, see the Firmware User’s Guide chapter on “Multiple Network
Address Translation (MultiNAT)“.
information on Network Address Translation, see the Firmware User’s Guide chapter on “Multiple Network
Address Translation (MultiNAT)“.
2.
From the IP Addressing menu item, choose between Unnumbered and Numbered addressing. Numbered is
the default for ADSL. It assigns a unique IP address to the ADSL WAN inter face, as required by most ISPs’
routers. Unnumbered may be used for simpler configurations such as point-to-point applications.
the default for ADSL. It assigns a unique IP address to the ADSL WAN inter face, as required by most ISPs’
routers. Unnumbered may be used for simpler configurations such as point-to-point applications.
Connection Profile 1: Easy Setup Profile
Connection Profile Name: Easy Setup Profile
Address Translation Enabled: Yes
IP Addressing... Numbered
IP Addressing... Numbered
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
PPP Authentication... None
PREVIOUS SCREEN NEXT SCREEN