TomTom 335le Guia Do Utilizador

Página de 66
Before you start
3.
6
Before you start
Switching on and off
Install your TomTom ONE/XL/XXL navigation device in your car following the 
instructions in the installation section at the start of this book.
To switch on your navigation device, press and hold the On/Off button until 
you see the start-up screen. The first time you switch on your device, it may 
take a short time to start.
To set up your device you need to answer a few questions by tapping the 
screen.
Device not starting
In rare cases, your TomTom ONE/XL/XXL navigation device may not start cor-
rectly or may stop responding to your taps.
First, check that the battery is properly charged. To charge the battery, con-
nect your device to the car charger. It can take up to 2 hours to fully charge the 
battery.
If this does not solve the problem, you can reset the device. To do this, press 
and hold the On/Off button for 15 seconds and release the button when your 
device begins to restart.
Charging your TomTom ONE/XL/XXL
Before you use your ONE/XL/XXL for the first time, it’s a good idea to charge 
it fully. 
The battery in your TomTom ONE/XL/XXL navigation device charges when 
you connect it to the car charger or to your computer.
There is no charging light on your ONE/XL/XXL. To check the battery status 
and see when your ONE/XL/XXL is charging, switch on your device and tap 
the bottom right-hand corner of the screen in the Driving View. The battery 
status is shown on the next page.
When you connect your device to a computer, you are asked if you want to 
connect to the computer. If you select No and then do not tap the screen 
within three minutes, the device will automatically switch off. This happens so 
that the battery can charge faster.
Note: You should plug the USB connector directly into a USB port on your 
computer and not into a USB hub or USB port on a keyboard or monitor.