Nokia 8850 Manual Suplementar
AT Command Set for Nokia 8850
3
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Introduction
This document describes the AT commands supported by Nokia 8850. A short
description, the syntax, the possible setting values and responses of the AT
commands are presented.
description, the syntax, the possible setting values and responses of the AT
commands are presented.
Computers use AT commands to communicate with modems. Most communications
applications, however, have a user friendly interface that hides these AT command
from the user. You issue AT commands via your communications application. When
the software in the Nokia product has received an AT command, it responds with a
message that is displayed on the screen of the device you are using. Some
command parameters may not be supported by the phone, and using those
parameters causes an error response.
applications, however, have a user friendly interface that hides these AT command
from the user. You issue AT commands via your communications application. When
the software in the Nokia product has received an AT command, it responds with a
message that is displayed on the screen of the device you are using. Some
command parameters may not be supported by the phone, and using those
parameters causes an error response.
Note that the "AT" or "at" prefix must be included at the beginning of each command
line.
line.