Nokia 8850 Manual Suplementar
AT Command Set for Nokia 8850
41
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Parameters:
<n>:
sets/shows the result code presentation
status in the TA:
status in the TA:
0
disable
1
enable
<str>:
string type USSD-string (when <str>
parameter is not given, network is not
interrogated):
parameter is not given, network is not
interrogated):
- if <dcs> indicates that GSM 03.38
default alphabet is used:
- if TE character set other than "HEX"
(refer command Select TE Character
Set +CSCS):
default alphabet is used:
- if TE character set other than "HEX"
(refer command Select TE Character
Set +CSCS):
ME/TA converts GSM alphabet into
current TE character set according to
rules of GSM 07.05, Annex A
current TE character set according to
rules of GSM 07.05, Annex A
- if TE character set is "HEX":
ME/TA converts each 7-bit character of
GSM alphabet into two IRA character long
hexadecimal number (e.g. character P
(GSM 23) is presented as 17 (IRA 49 and
55))
GSM alphabet into two IRA character long
hexadecimal number (e.g. character P
(GSM 23) is presented as 17 (IRA 49 and
55))
- if <dcs> indicates that 8-bit data
coding scheme is used:
coding scheme is used:
ME/TA converts each 8-bit octet into two
IRA character long hexadecimal number
(e.g. octet with integer value 42 is
presented to TE as two characters 2A
(IRA 50 and 65))
IRA character long hexadecimal number
(e.g. octet with integer value 42 is
presented to TE as two characters 2A
(IRA 50 and 65))
<dcs>:
GSM 03.38, Cell Broadcast Data Coding
Scheme in integer format (default 0)
Scheme in integer format (default 0)
<m>:
0
0
no further user action required (network
initiated USSD-Notify, or no further
information needed after mobile initiated
operation)
initiated USSD-Notify, or no further
information needed after mobile initiated
operation)
1
further user action required (network
initiated USSD-Request, or further
information needed after mobile initiated
operation)
initiated USSD-Request, or further
information needed after mobile initiated
operation)
+DR Data Compression Reporting
This command controls the presentation of +DR:<compr> intermediate result code.
(V.25ter section 6.6.2.)
(V.25ter section 6.6.2.)
Syntax:
AT+DR=<mode>
Set reporting mode. The default option is
0.
0.
AT+DR?
Query current setting.
Response is +DR: <mode>
Response is +DR: <mode>
AT+DR=?
Show supported modes.
Response is +DR:(list of supported
<mode>'s).
Response is +DR:(list of supported
<mode>'s).
Parameters:
<mode>
0
0
data compression reporting disabled
1
data compression reporting enabled
<compr>
NONE
NONE
data compression not in use
V42B
V.42bis in use in both directions
V42B RD
V.42bis in use in receive direction only
V42B TD
V:42bis in use in transmit direction only
MNP5
MNP5 in use