Rocketfish RF-RBWS02 Guia Do Utilizador
17
RF-RBWS02
Using the remote control
• To avoid possible failure, read the following instructions and handle the
remote control properly.
• Do not drop or jar the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of
excessive heat.
Caution
: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type of battery.
Note
: Remove the battery from the remote control when it is not to be used for a long
period. Otherwise it might be damaged due to battery leakage.
Connecting the audio jacks
When the sender/receiver is connected to a power outlet, and an
audio source is attached to its 3.5mm AUDIO IN jack, it
audio source is attached to its 3.5mm AUDIO IN jack, it
is
sensed
automatically and used as a stereo sender. When the sender/receiver
is connected to a power outlet, and a speaker system is attached to
the AUDIO OUT jack, the output is always active assuming the RX LED
is lit and there is a valid sending device.
is connected to a power outlet, and a speaker system is attached to
the AUDIO OUT jack, the output is always active assuming the RX LED
is lit and there is a valid sending device.
Note
: For devices that use variable line level out like the headphone jack on a personal
media player make sure that you turn the volume up to at least 80% of the maximum
volume on the device. This ensures that you keep your signal to noise ratio high and
maximize the sound quality.
volume on the device. This ensures that you keep your signal to noise ratio high and
maximize the sound quality.
A few configurations are shown here to provide ideas for your own
use:
use:
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 17 Thursday, August 27, 2009 7:39 PM