Vivitar 2005 Manual Do Utilizador

 
 

Make sure that you have loaded the batteries correctly.    Press and hold the power button for 
two seconds.    The camera will power up.    The LEDs will illuminate and the LCD display 
screen will turn on.    Please press and hold the power button again for two seconds to power 
off.    (Note: If you will not use the camera for a long time remove the batteries to prevent 
damage by potential battery leakage.) 
 

 
 
The battery level indicator icon will display in the lower left-hand corner of the display screen when 
the camera is on.    The indicator is a three-segment gauge: 

 

: Full battery capacity 

 

: Low battery capacity 

 

: Virtually out of power, camera will power off automatically soon 

When the camera is out of power, it will power off automatically. 

 

 
 
Press the Menu button to select capture mode: 

.  Use left and right buttons (“

” and “

”) to select 

capture mode “

” (Figure 5).    Press OK to open the submenu as shown in Figure 6. 

Figure 5 –

Capture mode icon

 

  : Single image capture 

Figure 6 –

Capture modes

 

：

Video clip mode 

 

: Burst mode (4 images) 

Note: the default mode is single image capture 

 

    “SF”,“F”and  “E”indicate image resolution (quality.)    You may 

select image resolution from the setup menu. 

 

SF (Super-Fine), 1600 x 1200 (2 megapixel) 

 

F (Fine), 1280 x 960 

 

E (Economy), 640 x 480 

Note: The default setting is Super-Fine 
 

 

9