Hitachi c18dl cordless circular saw Guia Do Utilizador
10
English
SPECIFICATIONS
1. Cordless Circular Saw (C18DL)
1. Cordless Circular Saw (C18DL)
2. Battery Charger
ASSEMBLY AND OPERATION
Motor
DC motor
No-load speed
3,400/min
Max. Cutting Depth
2-1/4” (57 mm)
Blade Size
6-1/2” (165 mm) D
×
5/8” (15.9 mm) H
×
1/16” (1.6 mm) T
Model
EBM1830
Type
Lithium – ion battery
Battery
Voltage
DC 18V
Charging & discharging
about 1,300 times
frequency
Light Bulb
12V, 5W
Weight
7.1 lbs. (3.2 kg)
Model
UC18YRL
Input power source
Single phase: AC120V 60Hz
Charging time
Approx. 45 min (At a temperture of 68°F (20°C))
Charging voltage
DC 7.2 – 18V
Charging current
DC 3.5A
Weight
1.3 lbs. (0.6 kg)
NOTE: The charging time may vary according to ambient temperature and power source voltage.
APPLICATIONS
䡬 Cutting Various types of wood.
䡬 Cutting Various types of wood.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
䡬 How to install the battery.
OF BATTERY
䡬 How to install the battery.
Align the battery with the groove in tool handle
and install it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 5).
and install it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 5).
Fig. 5
䡬 How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches on both sides of the battery
(Fig. 5).
pressing the latches on both sides of the battery
(Fig. 5).
CHARGING METHOD
The following is an explanation of charging methods
when using the battery charger UC18YRL.
The following is an explanation of charging methods
when using the battery charger UC18YRL.
NOTE
Before plugging into the receptacle, make sure the
following points.
following points.
䡬 The power source voltage is stated on the
nameplate.
䡬 The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
Battery
Handle
Insert
Pull
out
out
Latch
Push