Frigidaire fpcc3085ks Guia Do Utilizador

6

The ceramic cooktop has inductors and radiant surface 

elements located below the surface of the glass. The 

design of the ceramic cooktop outlines the area of the 

surface element underneath. Make sure the diameter of 

the pan matches the diameter of the element outline on 

the cooktop (See Figs. 1 to 4).
Only fl at-bottom cookware should be used. The type 

and size of cookware, the number of surface elements 

in use and their settings are all factors that will affect 

the amount of heat that will spread to areas beyond the 

surface elements. The areas surrounding the elements 

may become hot enough to cause burns.



Please read detailed instructions for ceramic glass 

cooktop cleaning in the General Care & Cleaning 

section and Before You Call checklist section of this 

Use and Care Guide.

The element temperature rises gradually and evenly. 

As the temperature rises, the element will glow red. To 

maintain the selected setting, the element will cycle ON 

and OFF. The heating element retains enough heat to 

provide a uniform and consistent heat during the OFF 

cycle. For effi cient cooking, turn OFF the element several 

minutes before cooking is complete. This will allow 

residual heat to complete the cooking process.

Your cooktop is equipped with radiant surface radiant 

elements with different wattage ratings. The ability to 

heat food quicker and in larger volumes increases as the 

element wattage increases.
The surface elements are located on the 30” cooktop as 

follows (Figure 1):

•  Two 7 inch radiant elements are located at the left front 

and rear positions.

•  One mid-position radiant element located between left 

front and rear element. Connects with front element to 

form Bridge element.

•  One 6 inch induction element located at the right rear 

position.

•  One 10 inch induction element located at the right front 

position.

The surface elements are located on the 36” cooktop as 

follows (Figure 2):

•  Two 7 inch radiant elements are located at the left front 

and rear positions.

•  One mid-position radiant element located between left 

front and rear element. Connects with front element to 

form Bridge element.

•  One 6 inch radiant element located at the center rear 

position.

•  One 6 inch induction element located at the right rear 

position.

•  One 10 inch induction element located at the right front 

position.