Frigidaire fpcc3085ks Guia Do Utilizador

8



See Recommended Setting for Surface Element table on 

page 7.

The cooktop has 1 or 2 SINGLE radiant surface elements: 

the LEFT REAR position and the center rear position (on 

the 36” model only). The left rear element may also be 

used with the Bridge element (Figures 1 and 2).

1.  Place correctly sized cookware on the radiant surface 

element.

2.  Push in and turn the surface control knob in either 

direction to the desired setting (Figure 3). 

3.  Turn the knob to adjust the setting if desired. Start 

most cooking operations on a higher setting and then 

turn to a lower setting to fi nish cooking. Each surface 

element provides a constant amount of heat at each 

setting. A glowing red surface heating area extending 

beyond the bottom edge of the cookware indicates 

the cookware is too small for the surface heating 

area.

4.  When cooking has completed, turn the surface 

control knob to OFF before removing the cookware.

Figure 1

Figure 2

Radiant  surface  elements  may  appear  to  have  cooled 

after  they  have  been  turned  OFF.  HE  (Hot  Element) 

message will turn ON and will continue to glow until the 

glass cooktop has cooled down to a moderate level. The 

glass surface may still be hot and burns may occur if 

the glass surface is touched before the indicator light has 

turned OFF. The message may remain on even though 

the controls are turned OFF.

cooktop when it is in use. These items could melt or 

ignite. Potholders, towels or wooden spoons could catch 

fi re if placed too close to the surface elements.

cooktop. If these items melt on the cooktop they will 

damage the ceramic cooktop.



The surface “Element On” indicator lights will glow 

when one or more elements are turned on. A quick 

glance at these indicator lights when cooking is fi nished 

is an easy check to be sure all surface elements are 

turned off.

Figure 3