Whirlpool wgd6600 Guia Do Utilizador

Dryer Results

Clothes are not drying satisfactorily, drying times are too
long, or load is too hot

■

Is the lint screen clogged with lint?

Lint screen should be cleaned before each load.

WARNING

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death
or fire.

■

Is the exhaust vent or outside exhaust hood clogged with
lint, restricting air movement?

Run the dryer for 5-10 minutes. Hold your hand under the
outside exhaust hood to check air movement. If you do not feel
air movement, clean exhaust system of lint or replace exhaust
vent with heavy metal or flexible metal vent. See the Installation
Instructions.

■

Are fabric softener sheets blocking the grille?

Use only one fabric softener sheet, and use it only once.

■

Is the exhaust vent the correct length?

Check that the exhaust vent is not too long or has too many
turns. Long venting will increase drying times. See the
Installation Instructions.

■

Is the exhaust vent diameter the correct size?

Use 4" (102 mm) diameter vent material.

■

Is the dryer located in a room with temperature below

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above
45ºF (7ºC).

■

Is the dryer located in a closet?

Closet doors must have ventilation openings at the top and
bottom of the door. The rear of the dryer requires 5½" (140 mm)
of airspace, and the sides and front of the dryer require a
minimum of 1" (25 mm). See the Installation Instructions.

■

Has the Air Only modifier been selected?

Select the right temperature for the types of garments being
dried. See “Modifiers.”

■

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

■

Are clothes coming out of the Quick Refresh cycle with
damp or wet spots?

Under certain environmental or installation conditions you may
experience underdrying. Select the Timed Dry cycle (20 min.
default time), which can be customized by choosing
temperature by pressing TEMP and/or cycle time by pressing
the Time Adjust up or down buttons.

Cycle time too short

WARNING

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

■

Is the automatic cycle ending early?

The load may not be contacting the sensor strips. Level the
dryer.

Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.

Lint on load

■

Is the lint screen clogged?

Clean lint screen. Check for air movement.

Stains on load or drum

■

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments. Do not use fabric softener sheets in the
Enhanced Touch Up or Quick Refresh Steam cycles.

Drum stains are caused by dyes in clothing (usually blue jeans).
This will not transfer to other clothing.

Loads are wrinkled

■

Was the load removed from dryer at the end of the cycle?

Select Enhanced Touch Up Cycle to tumble the load with water
and heat to help smooth out wrinkles from a load left in the
dryer.

■

Was the dryer overloaded?

Dry smaller loads that can tumble freely. Smaller loads of

one to four garments yield best results with Quick Refresh
Cycle. Results may also vary depending on fabric type. This
cycle is best for reducing wrinkles and odors from loads
consisting of wrinkle-free cotton, cotton polyester blends,
common knits, and synthetics.