3com 8807 Guia Do Utilizador
794
C
HAPTER
69: D
EVICE
MANAGEMENT
n
The precision of switch timer is 1 minute. The switch will reboot in one minute
when time comes to the specified rebooting point.
when time comes to the specified rebooting point.
Specifying the Bootstrap
Programs for the Switch
You can specify two bootstrap programs for both active and standby SRPCs of the
switch, with one used as the primary program and the other as the backup
program. You can use the following command to specify the bootstrap programs
for the switch:
switch, with one used as the primary program and the other as the backup
program. You can use the following command to specify the bootstrap programs
for the switch:
If the switch fails to boot up through the specified bootstrap program, it retries to
boot up by using a program in the flash memory or the CF card. If it fails again,
the switch fails to start.
boot up by using a program in the flash memory or the CF card. If it fails again,
the switch fails to start.
The switch select one application program as bootstrap program from Flash or CF
card according to the different values of flag BootDev. The detail is as follows:
card according to the different values of flag BootDev. The detail is as follows:
■
There are two primary bootstrap programs: one is in the Flash card (assume it is
A); the other is in the CF card (assume it is B).
A); the other is in the CF card (assume it is B).
■
There are two backup programs too: one is in the Flash card (assume it is C);
the other is in the CF card (assume it is D).
the other is in the CF card (assume it is D).
■
There is one flag BootDev.
You can view or modify the names of the bootstrap programs and enable
equipment flag BootDev.
equipment flag BootDev.
The detailed rules that the switch follows in selecting a bootstrap program are as
follows in Table 3-4.
follows in Table 3-4.
Cancel the parameter configuration of timing
reboot function of the switch
reboot function of the switch
undo schedule reboot
Check the parameter configuration of the
reboot terminal service of the current switch
reboot terminal service of the current switch
display schedule reboot
Table 745 Enable the Timing Reboot Function
Operation Command
Table 746 Specify a bootstrap program for the switch
Operation
Command
Remarks
Specify the bootstrap
program for the switch
program for the switch
boot boot-loader { primary
| backup } file-url [ slot
slot-number ]
| backup } file-url [ slot
slot-number ]
Execute this command in user
view.
view.
Table 747 The sequence of bootstrap program selection by the switch
BootDev Value of for boot
from primary bootstrap
program
from primary bootstrap
program
BootDev value for boot
from backup bootstrap
program
from backup bootstrap
program
Bootstrap program
selection sequence
selection sequence
0
0
A, C, B, D
0
1
A, D, B, C
1
1
B, D, A, C
1
0
B, C, A, D