Lexmark c752 Guia De Referência
![Lexmark](https://files.manualsbrain.com/attachments/878cae5fca737841ce37f41a7ee73881a8b54f60/common/fit/150/50/823435a5b9c868f91a4b7f8b99ddfd9b9c699edf1f6ff104003e82a92d7f/brand_logo.png)
Interfaces
8-24
SLCTIN* Receiver for the Lexmark C752
The following diagram illustrates the SLCTIN* receiver for the Lexmark C752.
Serial Interface
The serial interface allows data to flow back and forth between the computer and the
printer. However, the serial interface transfers data at a slower rate than the parallel
interface.
printer. However, the serial interface transfers data at a slower rate than the parallel
interface.
If a serial connector is required, you may be able to install an RS-232C Serial Interface
Card, an External Serial Adapter, or an RS-232C Serial/Parallel 1284-C Interface
Card. Refer to your printer user documentation for more information.
Card, an External Serial Adapter, or an RS-232C Serial/Parallel 1284-C Interface
Card. Refer to your printer user documentation for more information.
The External Serial Adapter supports two serial interface standards: RS-232C and
RS-422. The RS-422 serial interface provides more protection from electrical noise
than RS-232.
RS-422. The RS-422 serial interface provides more protection from electrical noise
than RS-232.
Use RS-232C serial interface if the printer is more than 3.04 m (10 ft) from the
computer but less than 15.24 m (50 ft) away. (You can also use a 6.1 m (20 ft) Lexmark
cable to connect a printer and a computer located up to 20 feet apart.)
computer but less than 15.24 m (50 ft) away. (You can also use a 6.1 m (20 ft) Lexmark
cable to connect a printer and a computer located up to 20 feet apart.)
Use RS-422 if your computer is more than 15.24 m (50 ft) away from the printer. You
may need to purchase an RS-422 adapter and software for your computer to run
RS-422. Refer to your computer documentation for more information. You also need
to purchase a custom cable for the serial interface, because serial RS-422 interface
pinouts are usually unique to each computer.
may need to purchase an RS-422 adapter and software for your computer to run
RS-422. Refer to your computer documentation for more information. You also need
to purchase a custom cable for the serial interface, because serial RS-422 interface
pinouts are usually unique to each computer.
+5V, 5%
1.5K ohm ±10%
FCT 2827 or
FCT 2828
FCT 2828
GND
1650 pF ±20%
Connector
Pin
Pin
56 ohm ±10%