Sony CDX-GT65UIW Manual

Supplied accessories:

Card remote commander: RM-X151
Parts for installation and connections (1 set)

Optional accessories/equipment:

BUS cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
USB connection cable for iPod: RC-100IP
HD Radio™ tuner: XT-100HD

Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.

Design and specifications are subject to change
without notice.

System requirements for using
SensMe™

Computer

• CPU/RAM

– IBM PC/AT compatible machine
– CPU: Intel Pentium III Processor 450 MHz or

higher

– RAM: 256 MB or more (For Windows XP), 512

MB or more (For Windows Vista or later)

• USB port

Windows XP, Windows Vista, Windows 7
For details on compatible editions or Service Pack, visit
the following support site:
http://esupport.sony.com
http://www.sony.com/mobileAV

Monitor

High color (16-bit) or more, 800

× 600 dots or more

Other

Internet connection

Notes
• The following system environments are not

supported.
– Non IBM PC type computers, such as Macintosh,

etc.

– Homemade computers
– OS upgraded computers
– Multi-display environment
– Multi-boot environment
– Virtual machine environment

• Depending on the computer condition, operation

may not be possible even with the recommended
environment.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.

If the problem is not solved, visit the following
support site.

General

No power is being supplied to the unit.

• Check the connection or fuse.
• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.

t Turn on the unit.

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The ATT function is activated, or the Telephone ATT

function (when the interface cable of a car telephone
is connected to the ATT lead) is activated.

• The position of the fader control “FADER” is not set

for a 2-speaker system.

No beep sound.

• The beep sound is canceled (page 24).
• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.

t Store again into the memory.

• The power supply lead or battery has been

disconnected or it is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.

The leads are not matched correctly with the car’s
accessory power connector.

During playback or reception, demonstration
mode starts.

If no operation is performed for 5 minutes with
“DEMO-ON” set, demonstration mode starts.
t Set “DEMO-OFF” (page 24).

The display disappears from/does not appear
in the display window.

• The dimmer is set to “DIMMER-ON” (page 24).
• The display disappears if you press and hold

(SOURCE/OFF).

t Press (SOURCE/OFF) on the unit until the

display appears.

• The connectors are dirty (page 27).

continue to next page

Support site

http://esupport.sony.com
http://www.sony.com/mobileAV