Zanussi ZEV6340NBA Manual Do Utilizador

The hob deactivates.

You put something on the sensor
field  .

Remove the object from the sen-

sor field.

Residual heat indicator does not

come on.

 The zone is not hot because it

operated only for a short time.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.

The sensor fields become hot.

The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

zones if possible.

 comes on.

Automatic Switch Off operates.

Deactivate the hob and activate it

again.

 comes on.

The Child Safety Device function

operates. 

Refer to "Daily use" chapter.

 and a number come on.

There is an error in the hob.

Disconnect the hob from the

electrical supply for some time.

Disconnect the fuse from the

electrical system of the house.
Connect it again. If   comes on

again, speak to an Authorised

Service Centre.

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating

plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass

surface) and an error message that comes on.

Make sure, you operated the hob correctly. If

not the servicing by a service technician or

dealer will not be free of charge, also during the

warranty period. The instructions about the

Service Centre and conditions of guarantee are

in the guarantee booklet.

Refer to Safety chapters.

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use

the following (or higher) mains cable type:

H05BB-F Tmax 90°C. Speak to your local

Service Centre.