Zanussi ZOA35526XK Manual Do Utilizador

Be careful when you remove the

shelf supports. The catalytic panels

are not attached to the oven walls

and can fall out when you remove

the shelf supports.

Pull the front of the

shelf support away

from the side wall.

Hold the rear shelf

runners and catalytic

panel in place with

the other hand.

Pull the rear end of

the shelf support

away from the side

wall and remove it.

Install the shelf supports in the opposite

sequence.

The retaining pins on the telescopic

runners must point to the front.

Do not clean the catalytic surface

with oven sprays, abrasive cleaning

agents, soap or other cleaning

agents. This will damage the

catalytic surface.

Spots or discolouration of the

catalytic surface have no effect on

catalytic properties.

Keep children away when you clean

the oven at a high temperature. The

oven surface becomes very hot and

there is a risk of burns.

Before activating the catalytic

cleaning remove all the accessories

from the oven.

The walls with a catalytic coating are self-

cleaning. They absorb fat which collects on the

walls while the appliance operates.

To support the self-cleaning procedure, heat

the empty oven on a regular basis.
1. Clean the oven floor with warm water and

washing up liquid, then dry it.

2. Set the function  .

3. Set the oven temperature to 250 °C and let

the oven operate for 1 hour.

4. When the appliance is cool, clean it with a

soft and moist sponge.

The oven door has two glass panels. You can

remove the internal glass panel to clean it.

Do not use the appliance without the

internal glass panel.

The direction in which you open the

door depends on your oven model.

You open the door from the right

side in some models and from the

left side in others.

Press the buttons at

the sides of the door

trim (A) on the upper

cover and pull it

upwards to remove it.

Hold the inner glass

B tightly with both

hands and slide it

upwards to remove it

from its initial

position. Make sure

that you tightly hold

glass B to prevent

the glass from falling.

Clean the door with a wet sponge and rub it dry

with a soft cloth. Do not use steel wool, acids or

abrasive cleaning agents because they can

damage the surface.
When the oven door is clean, install the glass

panel in the opposite sequence. The screen-

printing zone must face the inner side of the

door. Make sure that after the installation the

surface of the glass panel frame on the screen-

printing zones is not rough when you touch it.

Make sure that you put the glass panel in the

rubber distance holders.