Zanussi ZCG63040XA Manual Do Utilizador

3. Remove the glass panels.

To replace the glass panels, do the

same steps in reverse. Before you

lower the trim, attach the A trim part to

the door. Refer to the image.

REPLACING THE LAMP
Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

WARNING! Danger of electrocution!

Disconnect the fuse before you

replace the lamp.

The lamp and the lamp glass cover

can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.

The lamp glass cover is at the back of

the cavity.

1. Turn the lamp glass cover counterclockwise to

remove it.

2. Clean the glass cover.

3. Replace the oven lamp with a suitable 300 °C

heat-resistant oven lamp.

Use the same oven lamp type.

4. Install the glass cover.

WARNING! Refer to Safety chapters.

You cannot activate the appli-

ance.

The appliance is not connec-

ted to an electrical supply or it

is connected incorrectly.

Check if the appliance is cor-

rectly connected to the electri-

cal supply.

You cannot activate the appli-

ance.

The fuse is blown.

Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

You cannot activate the appli-

ance.

The appliance is too hot.

Wait for the appliance to cool

down.

The burners do not work.

There is no gas supply.

Check the gas connection.

There is no spark when you try

to activate the spark generator.

Burner cap and crown are

placed incorrectly.

Place the burner cap and

crown correctly.

The flame extinguishes immedi-

ately after ignition.

Thermocouple is not heated up

sufficiently.

After lightning the flame, keep

the knob pushed for equal or

less than 10 seconds.

The flame ring is uneven.

Burner crown is blocked with

food residues.

Make sure that the injector is

not blocked and the burner

crown is clean.

The flame colour is orange or

yellow.

 

The flame can look orange or

yellow in some areas of the

burner. This is normal.