Zanussi ZCK68300B Manual Do Utilizador

Make sure that the wall is made of a solid

material. If not, you need to make the wall

sufficiently strong to hold the weight.

Make sure that the surface behind the

appliance is smooth.

2. Put the appliance in the middle of the space

between the cupboards.

If the space is larger than the width of the

appliance, you must adjust the side

measurement.

3. Install the anti-tilt protection (A)

approximately 77 mm below the top surface

of the appliance and 50 mm from the left or

right side of the appliance into the circular

hole on the bracket. Screw it into the wall.

50 mm

77 mm

4. Check that the anti-tilt protection (A) fits

minimum 20 mm into the hole in the rear

wall of the appliance (B) when you push the

appliance.

These instructions are only valid in

the countries whose symbols appear

on this booklet's cover.

Gas category:

I2H

Gas supply:

G20 (2H) 20 mbar

Voltage:

220-240 V

Frequency:

50/60 Hz

Auxiliary

1

70

3412

Semi-rapid

1.9

96

6483

Rapid

3

119

10236

Use a flexible pipe in compliance with the

regulation in force. Make sure they do not come

in touch with mobile parts and are not

squeezed.

Only a qualified and competent

person can do the gas installation.

Before you connect te gas,

disconnect the appliance from the

electricity supply or switch off the

fuse in the fuse box. Close the

primary valve of the gas supply.

Supply piping should not be less

than R3/8. Connection is made to

the Rc 1/2 (1/2 “ B.S.P.) female

threaded. The entry pipe is located

just below the hob level on the rear

left hand side of the appliance.

The gas supply ramp is on the rear

side of the appliance.

Only liquid sealants can be used

when the inlet gas pipe is fitted i.e.:

do not use the P.T.F.E. sealant tape.

When the installation is complete,

carry out a gas tightness test and

make sure that the seal of each pipe

fitting does not leak.