Zanussi ZCK68300B Manual Do Utilizador

Use flexible tubing, which comply

with the BS.669 current edition.

The gas bayonet connector must be

in the marked area.

A

250

B

680

C

50

D

250

E

580

The Rapid injector is used as a pressure test

point.
1. Connect the pressure gauge to the Rapid

injector.

2. Examine the supply pressure by turning the

Rapid burner and one other burner fully on,

and lighting them. The pressure must be:

a) 20 mbar for Natural Gas

b) 29 mbar for LPG, butane only

c) 37 mbar for LPG, propane only.

3. Turn the taps off and disconnect the

pressure gauge.

4. Make sure that all burners work correctly.

1. Lift the lid.

2. Put on the burner crowns and caps. Make

sure that they are correctly seated.

3. Put on the pan supports.

4. Light one of the hob burners. 

To light the hob burner refer to the "Ignition

of the hob burners".

Check if the flame is regular.

Check each of the burners.

5. Turn the knob for the hob to the off position.

1. Lift the lid.

2. Light one of the hob burners. 

To light the hob burner refer to the "Ignition

of the hob burners".

3. Close the lid. There should be no gas

supply to the hob burners. The burner goes

out.

4. Turn the knob to the off position and lift the

lid. The gas supply should be restored to

the hob burners, when you turn the knob on.

The manufacturer is not responsible

if you do not follow the safety

precautions from Safety chapters.

This appliance is supplied without a main plug

or a main cable.

• The recommended cross-section area is six

square millimetres (6 mm²).

• When you refit the mains terminal cover,

make sure that the lower tabs are located

inside the bottom edge of the aperture,

before you fix the two screws into the top

edge of the mains terminal cover.

• Make sure that the cover is securely

fastened.