Zanussi ZQA14031DA Manual Do Utilizador

The appliance does not operate.

The appliance is switched off.

Switch on the appliance.

 

The mains plug is not connected

to the mains socket correctly.

Connect the mains plug to the

mains socket correctly.

 

There is no voltage in the mains

socket.

Connect a different electrical ap-

pliance to the mains socket. Con-

tact a qualified electrician.

The appliance is noisy.

The appliance is not supported

properly.

Check if the appliance stands

stable.

The lamp does not work.

The lamp is in stand-by.

Close and open the door.

The lamp is defective.

Refer to "Replacing the lamp".

The compressor operates contin-

ually.

Temperature is set incorrectly.

Refer to "Operation" chapter.

 

Many food products to be frozen

were put in at the same time.

Wait some hours and then check

the temperature again.

 

The room temperature is too

high.

Refer to climate class chart on

the rating plate.

 

Food products placed in the ap-

pliance were too warm.

Allow food products to cool to

room temperature before storing.

The door is not closed correctly.

Refer to "Closing the door".

Water flows into the refrigerator.

The water outlet is clogged.

Clean the water outlet.

Food products prevent that water

flows into the water collector.

Make sure that food products do

not touch the rear plate.

The temperature in the appliance

is too low/too high.

The temperature regulator is not

set correctly.

Set a higher/lower temperature.

The door is not closed correctly.

Refer to "Closing the door".

The food products' temperature

is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Many food products are stored at

the same time.

Store less food products at the

same time.

The door has been opened often. Open the door only if necessary.

There is no cold air circulation in

the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.