Zanussi ZBF22456S1 Manual Do Utilizador

CAUTION! Make sure that the mains

cable can move freely.

1. If necessary cut the adhesive sealing strip and

then apply it to the appliance as shown in

figure.

x

x

2. Drill the unit using a Ø 2.5 mm drill (10 mm

max. penetration).

3. Fix the square fitting to the appliance.

13mm

Ø 2,5

4. Install the appliance in the niche.

5. Push the appliance in the direction of the

arrows (1) until the upper gap cover stops

against the kitchen furniture.

6. Push the appliance in the direction of the

arrows (2) against the cupboard on the

opposite side of the hinge.

7. Adjust the appliance in the niche.

Make sure that the distance between the

appliance and the cupboard front-edge is 44

mm.

The lower hinge cover (in the accessories bag)

makes sure that the distance between the

appliance and the kitchen furniture is correct.

Make sure that the clearance between the

appliance and the cupboard is 4 mm.

8. Open the door. Put the lower hinge cover in

position.

4mm

44mm

9. Attach the appliance to the niche with 4

screws.

10. Remove the correct part from the hinge cover

(E). Make sure to remove the part DX, in the

case of right hinge, SX in opposite case.

11. Attach the covers (C, D) to the lugs and the

hinge holes.

12. Install the vent grille (B).

13. Attach the hinge covers (E) to the hinge.

14. Connect the appliance laterally to the kitchen

furniture sidewall.

15. Disconnect the parts (Ha), (Hb), (Hc) and (Hd).