Zanussi ZDM17301WA Manual Do Utilizador

E3

Required temperature is not

reached.

Malfunction of heating element.

E4

Overfilled.

Too much inlet water or some

dishwasher element leaks.

Make sure to position the appliance

with minimum space of 50mm on both

sides of fully open door.

Keep 5 mm distance between both sides of the

appliance and the cabinet. There are two

possibilities for the cabinet hole for the appliance.

min. 

550 mm

min.

443mm

100

80

min. 

555mm

1

Power cord, drain hose and water supply line

hole. To facilitate a proper installation, position

the hole to the right or the the left of the

appliance.

WARNING! Do not use an extension

cord or and adapter plug with this

appliance.

WARNING! Do not cut or remove the

earthing.

WARNING! Make the electrical

connection with the power cord.

For rating voltage check the rating

plate.

max. 750 mm

• Connect the water drain hose into a drain pipe

with minimum diameter of 40 mm.

• Put the water drain hose directly into the sink.

use the special plastic support.

The water drain hose must be less than 750 mm

from the bottom of the appliance to prevent

problems during the draining phases.
Remove the sink plug when the appliance drains

water to prevent that the water goes back into the

appliance.
The extension of the water drain hose must not be

longer than 2 m. The internal diameter must not be

smaller than the diameter of the drain hose.
If you connect the water drain hose to a trap spigot

under the sink, remove the plastic membrane (A). If