Zanussi ZWD91683NW Manual Do Utilizador

You cannot set all dryness levels for

any type of laundry.

TIMED DRYING
The laundry can also be dried with a manual timed

drying:
1. Press 

 again and again to set the time value

(see the «Programmes for timed drying» table).

• The display shows 10 minutes. Each time

you press this touchpad the time value

increases by 5 minutes.

• The display shows the set time value: for

example – 

 .

• After some seconds the display shows a

new time value: 

. The appliance

calculates also the duration of the anti-

crease and the cooling phases.

2. Press 

 to start the programme.

• The display shows regularly a new time

value.

• The drying indicator   starts to flash.

• The display shows the door locked

indicator 

.

If you set only 10 minutes of drying,

the appliance performs only a cooling

phase.

If the laundry is not sufficient dry, set

again a short drying time.

END OF THE DRYING PROGRAMME
The appliance stops automatically.
• The acoustic signals operate (if they are active).
• In the display   comes on.
• The indicator 

 goes off.

• The last minutes of the drying cycle the

appliance performs a cooling and anti-crease

phase. The door is still locked.

When the door locked 

 goes off in the display,

you can open the door.
1. Press the button   for some seconds to

deactivate the appliance.

After some minutes from the end of the programme,

the energy saving function automatically

deactivates the appliance.

2. Remove the laundry from the appliance.
Make sure that the drum is empty.

3. Keep the door ajar, to prevent mildew and

odours.

4. Close the water tap.

WARNING! Refer to Safety chapters.

NON-STOP PROGRAMME
1. Press On/Off for some seconds to activate the

appliance.

2. Load the laundry one item at a time.

To have a good drying performance 

do not exceed the maximum drying

loads recommended in the user

manual. Do not set a spin speed

lower than the automatic speed of the

set programme.

3. Put the detergent and the additives in the

appropriate compartment.

4. Turn the programme dial to the washing

programme.

The display shows the indicators of the different

washing phases.

5. Set the available options.

1. Press   again and again until the display

shows one of the dryness level indicator:

•

: IRON DRY level indicator for cotton

items

•

: CUPBOARD DRY level indicator for

cotton and synthetic items

•

: EXTRA DRY level indicator for cotton

items

The display shows the indicator  . The time value

on the display is the duration of the washing +

drying cycles, calculated on a default load size.