Philips HR-1851 Manual Do Utilizador

 - Do not remove the pulp container when the appliance is operating.

 - Always unplug the appliance after use.

 - Noise level: Lc = 86 dB(A)

This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled 

properly and according to the instructions in this user manual, the appliance is safe to use based on 

scientific evidence available today.

 1 

 Clean all detachable parts (see chapter ‘Cleaning’).

 2 

 Pull the mains cord out of the cord storage compartment at the back of the appliance.

 3 

 To attach the spout to the juice collector, snap it into position (Fig. 2).

 4 

Place the juice collector onto the appliance and put the filter in the juice collector. Make sure

the filter is fitted securely onto the driving shaft (Fig. 3).

Always check the filter before use. If you detect any cracks or damage, do not use the appliance

and contact the nearest Philips service centre or take the appliance to your dealer.

 5 

 To attach the pulp container to the appliance, align the latch on the pulp container with the 

slot on the motor unit and then push the pulp container home. Hold the lid over the filter

and lower it into position.  (Fig. 4)

You  can also empty the pulp container while you are preparing juice. Switch off the appliance, 

remove the pulp container carefully and empty it.
Note: Reassemble the empty pulp container before you continue juicing.

 6 

 Snap the two clamps onto the lid to lock it into place (‘click’). Slide the pusher into the 

feeding tube.  (Fig. 5)

Make sure the clamps are locked into position on either side of the lid.

 7 

 Place the juice jug under the spout (Fig. 6).

The juice jug has a removable foam separator to separate the foam from the juice when you 

pour the juice into a glass.

locked the lid into place with the two clamps.
Do not operate the juicer for more than 40 seconds at a time when you juice heavy loads and

let it cool down afterwards. None of the recipes in this user manual constitute heavy loads.

 1 

Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding tube.

 2 

Make sure the spout is attached to the juice collector and the juice jug is placed under the

spout.

 3 

 Turn the control knob to setting 1 (low speed) or 2 (normal speed) to switch on the 

appliance.  (Fig. 7)

 - Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes, 

tomatoes, cucumbers and raspberries.

 - Speed 2 is suitable for all other kinds of fruits and vegetables.

 4 

Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating

filter with the pusher.

7