Fujifilm FUJIFILM X100S Manual Do Proprietário
58
1
Press the DRIVE button to display drive op-
tions. Press the command dial up or down to
highlight
highlight
I (CONTINUOUS), and the options
shown below will be displayed.
2
Press the command dial right or left
to choose from frame rates of ap-
proximately 6.0 fps (frames per sec-
ond) and 3.0 fps. Press MENU/OK to proceed
when settings are complete.
proximately 6.0 fps (frames per sec-
ond) and 3.0 fps. Press MENU/OK to proceed
when settings are complete.
3
Press the shutter button halfway to
focus.
4
Press the shutter button the rest
of the way down to start shoot-
ing. Shooting ends when the shut-
ter button is released, the selected
number of pictures has been taken,
or the memory card is full.
ing. Shooting ends when the shut-
ter button is released, the selected
number of pictures has been taken,
or the memory card is full.
R Focus and exposure are determined by the fi rst
frame in each series. The fl ash turns off automati-
cally; the previously-selected fl ash mode is restored
when burst shooting is turned off .
cally; the previously-selected fl ash mode is restored
when burst shooting is turned off .
R Frame rate varies with shutter speed and may slow
as more shots are taken.
R Additional time may be required to record pictures
when shooting ends.
R If fi le numbering reaches 999 before shooting is
complete, the remaining pictures will be recorded
to a new folder (
to a new folder (
P 89).
R In some drive modes, shooting may not begin if the
space available on the memory card is insuffi
cient.
Continuous Shooting (Burst Mode)
Continuous Shooting (Burst Mode)
Capture motion in a series of pictures.