Fujifilm FinePix T200 / T300 Manual Do Proprietário

For Your Safety

• Do not mix old and new batteries, bat-

teries with different charge levels, or 
batteries of different types.

• If the camera will not be used for an 

extended period, remove the batteries. 
Note that the camera clock will be reset.

•  The batteries may be warm to the touch 

immediately after use.  Turn the camera 
off and allow the batteries to cool be-
fore handling.

• Battery capacity tends to decrease at 

low temperatures.  Keep spare batter-
ies in a pocket or other warm place and 
exchange as necessary.  Cold batteries 
may recover some of their charge when 
warmed.

• Fingerprints and other stains on the 

battery terminals can impair battery 
performance.  Thoroughly clean the 
terminals with a soft, dry cloth before 
inserting them in the camera.

If the batteries leak, clean the bat-
tery compartment thoroughly be-
fore inserting new batteries.

If fluid from the battery comes 
into contact with skin or clothing, 
flush the affected area with water. 
If fluid enters your eyes, immediately 
flush the affected area with water and 
seek medical attention.  Do not rub your 
eyes.  Failure to observe this precaution 
could result in permanent visual impair-
ment.

■ Ni-MH Batteries
The capacity of Ni-MH batteries may be 
temporarily reduced when new, after 
long periods of disuse, or if they are re-
peatedly recharged before being fully 
discharged.  This is normal and does not 
indicate a malfunction.  Capacity can be 
increased by repeatedly discharging the 
batteries using the discharge option in 
the camera setup menu and recharg-
ing them using a battery charger (sold 
separately).

 

Q CAUTION: Do not use the discharge op-

tion with alkaline batteries.

The camera draws a small amount of 
current even when off.  Ni-MH batteries 
that have been left in the camera for an 
extended period may be drawn down 
to the point that they no longer hold a 
charge.  Battery performance may also 
drop if the batteries are run down in 
a device such as a flashlight.  Use the 
discharge option in the camera setup 
menu to discharge Ni-MH batteries.  Bat-
teries that no longer hold a charge even 
after repeatedly being discharged and 
recharged have reached the end of their 
service life and must be replaced.

Ni-MH batteries can be recharged in a 
battery charger (sold separately).  Bat-
teries may become warm to the touch 
after charging.  Refer to the instructions 
provided with the charger for more infor-
mation.  Use the charger with compatible 
batteries only.

Ni-MH batteries gradually lose their 
charge when not in use.

■ Disposal
Dispose of used batteries in accord with 
local regulations.

This section applies to all camera models. 
Use only FUJIFILM AC power adapters 
designated for use with this camera.  Oth-
er adapters could damage the camera.
• The AC power adapter is for indoor use 

only.

• Be sure the DC plug is securely con-

nected to the camera.

• Turn the camera off before disconnect-

ing the adapter.  Disconnect the adapter 
by the plug, not the cable.

•  Do not use with other devices.
•  Do not disassemble.
• Do not expose to high heat and hu-

midity.

• Do not subject to strong physical 

shocks.

• The adapter may hum or become hot 

to the touch during use.  This is normal.

• If the adapter causes radio interfer-

ence, reorient or relocate the receiving 
antenna.