Fujifilm FinePix S8100fd Manual Do Proprietário

82

[SHOOTING MENU]

A Select ] custom white balance (

➝p.73).

B Hold a piece of white paper under the light source for 

setting the white balance, so that it fills entire the 
screen. Then press the shutter button to set the white 
balance.

To use the white balance set previously, press the MENU/
OK without pressing the shutter button.

C When the correct exposure is measured, 

[COMPLETED!] appears. Press MENU/OK to confirm 
the setting.

You can change the white balance for a photographed image 
by using colored paper instead of white paper.

• In AUTO mode, the correct white balance may not be 

achieved for subjects such as close-ups of people’s 
faces and pictures taken under a special light source. 
Select the correct white balance for the light source.

• When the flash fires, the white balance (except for 

custom white balance) setting for the flash is used. 
Consequently, to achieve a particular effect, the flash 
mode should be set to Suppressed flash (

➝p.67).

• The specified custom white balance is retained until it is 

reset. This setting is retained even if the batteries are 
removed.

• The color tones may vary depending on the shooting 

conditions (light source, etc.).

• After taking the picture, check the image color (white 

balance).

• Explanation of Terms “White Balance” (

➝p.157)

• When [

 AUCTION MODE] is selected, custom white 

balance cannot be set.

] Custom white balance

Set the exposure 
compensation again, using 
a negative value (–) when 
[OVER] appears and a 
positive value (+) when 
[UNDER] appears (

➝p.63).

Setting the menu (

➝p.73)