Samsung C23A550U Manual Do Utilizador

Using "HUB Monitor"

2 Using "HUB Monitor"

To use the Internet using the HUB Monitor’s LAN network, configure the network settings as follows

according to the type of IP you will be using.

2.5.1

Dynamic IP

The dynamic IP address mode automatically configures the network settings on the PC using data sent

by a server, which allots an IP address. This is possible, owing to the “DHCP (Dynamic Host

Configuration Protocol)” service. The service consists of three steps: an IP address allotment request is

sent to the DHCP server when the PC boots up, the DHCP server that received the request transmits

network information such as the IP address to the PC, and the transmitted network information is

automatically registered to the network settings on the PC. The DHCP service is convenient and useful

especially in an environment where multiple PCs are used. Theoretically, the IP address changes each

time the PC boots up (or an IP allotment request is sent); in many cases, however, the existing IP address

is re-allotted. An Internet router performs two roles: creating a private IP address (NAT service) and

automatically allotting the IP address to each PC (DHCP service) at the same time.

When using your HUB Monitor’s or notebook PC’s LAN network, ensure you insert a LAN cable into

only one device. Otherwise, a system crash may occur.

Dynamic IP User

To use a dynamic IP address, connect a LAN to your HUB Monitor.

Next, go to the network settings menu and activate the HUB Monitor’s network device (select

“Use”).

Go to Control Panel

Network and Internet

Network and Sharing Center

Change

adapter settings. Next, right-click on the HUB Monitor’s network device (marked “LAN9512/

LAN9514 USB 2.0 to Ethernet 10/100 Adapter #7”) and select Use.

Using the network properties menu, check that the IP address mode for the HUB Monitor’s network

device is set to Auto.

→