AirLink raven gprs Manual Do Utilizador
AT Commands
62
Cingular GPRS Raven User Guide Version 2.01
TABLE 1.
Information and Status
Command
Details
I[n]
n=0 Product name (
i.e.
Raven
)
.
n=1 The Raven’s firmware (ALEOS) version, hardware
ID, and copyright.
ID, and copyright.
n=2 The OEM module's firmware version and relevant
hardware ID.
hardware ID.
n=3 The OEM module's unique ID (ESN).
&V
View active profile (the contents of the active registers).
*HOSTMODE?
The current host mode (AT, PPP, UDP, etc.). If the Raven
is not in AT mode, telnet into the modem to execute this
command.
is not in AT mode, telnet into the modem to execute this
command.
*NETCHAN?
The current active GPRS channel number .
*NETERR?
The network bit error rate.
*NETIP?
The current IP address of the modem reported by the
embedded OEM module (generally obtained from Car-
rier). This is the address to which packets can be sent in
order to contact the Raven from the Internet. Note: If there
is no current network IP, 0.0.0.0 may be displayed.
embedded OEM module (generally obtained from Car-
rier). This is the address to which packets can be sent in
order to contact the Raven from the Internet. Note: If there
is no current network IP, 0.0.0.0 may be displayed.
Use *NETALLOWZEROIP if you need to allow the dis-
play of an IP ending in a zero. See “*NETALLOWZE-
ROIP=n” on page 79.
play of an IP ending in a zero. See “*NETALLOWZE-
ROIP=n” on page 79.
*NETOK
Checks the GPRS network connection.
OK if connected.
ERROR if not connected.
*NETOP?
The current network operator (cellular carrier, i.e.
Cingu-
lar
) from the modem's firmware version.
*NETPHONE?
The modem's phone number (if applicable or obtainable).
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of
the Raven as a negative dBm value. The same information
is displayed with the command S202?.
the Raven as a negative dBm value. The same information
is displayed with the command S202?.