Panasonic KX-TGA272S Manual Do Utilizador

Your telephone company sends special signals (Voice mail tones) to
activate the VM indicator on the base unit. Press 

or 

to listen to

the dial tone. If you hear a series of dial tones followed by a continuous
dial tone, this is indication that a new message was recorded. Your phone
comes set to detect these tones (set to “On”). Minutes after you hang up
or after the phone stops ringing, the system will seize the phone line and
check if a message has been recorded. If a new message was recorded
at your telephone company, “Voice mail” will be displayed and the base
unit VM indicator will flash. Set this programming to “Off” when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a

continuous tone, or

—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.

1. Follow steps 1 to 4 of “Voice mail access number” on page 59.

2. Press 

á

at “VM tone detect”.

3. For KX-TG2700 users: Go to step 4.

For KX-TG2720 users: Press Ö (Line 1) or
Ñ (Line 2) to select the line. 

4. Select “Off” or “On” by pressing 

Ö

or 

Ñ

,

and press the soft key (

).

If you cleaned the charge contacts and charged the battery fully, but after a few
telephone calls, “Recharge battery” is displayed and/or “

” continues to

flash, or “Charge for 15HRS” and “

” are displayed, the battery may

need replacing. Please order a new Panasonic N4HHGMB00001 (HHR-P103)
battery at the telephone number shown on page 2. 

1

Press the notch on the handset
cover firmly and slide it as
indicated by the arrow.

---------------

H

VM tone detect

Save VM access#

VM tone detect

Line15678900

:On

IH

Ex. Registered to KX-TG2700