Panasonic tx-17lx2 Manual Do Utilizador

3

• This TV set is designed to operate on 15 volt AC 

adapter which operate on AC 220-240 V, 50 / 60 Hz.

•  To prevent damage which might result in elec tric shock 

or fi re, do not expose this TV set to rain or excessive 
moisture. This TV must not be exposed to dripping or 
splashing water and ob jects fi lled with liq uid, such as 
vases, must not be placed on top of or above the TV.

• Keep unneeded small parts and other objects out 

of the reach of small children. These objects can 
be accidentally swallowed. Also, be careful about 
packaging materials and plastic sheets.

•  WARNING: HIGH VOLTAGE!!!
  Do not remove the rear cover as live parts are 

accessible when it is removed. There are no user 
serviceable parts inside.

  Ensure that the mains plug is easily accessible.
• TV Games / Home Computers
  Extended use of TV games or home computers with 

any television set can cause a ‘shadow’ on the screen. 
This type of LCD panel phenomenon, can be limited 
by observing the following points:

• Reduce the brightness and contrast levels to a minimum 

viewing level.

• Do not allow a still picture to be displayed for an extended 

period, as this can cause a permanent after-image to remain 
on the LCD TV screen. 

• Examples of still pictures include logos, video games, computer 

images, teletext and images displayed in 4:3 mode.

• This type of LCD panel damage, is not an operating defect, 

and as such is not covered by the Panasonic warranty.

• The On / Off switch on this model does not fully 

disconnect the TV from the mains supply. Remove the 
mains plug from the wall socket before connecting or 
disconnecting any leads, or if the TV set is not used 
for a prolonged period of time.

Note:
If the set is not switched off when the TV station stops 
transmitting, it will automatically go to Standby mode 
after 30 minutes. This function will not operate when 
the TV is in AV mode.
• Cabinet and LCD panel care
  Remove the mains plug from the wall socket. The 

cabinet and LCD panel can be cleaned with a soft cloth 
moistened with mild detergent and water. Do not use 
solutions containing benzol or petroleum.

• When ambient temperature is cool, the picture may 

take a short time to reach normal brightness, but this 
is not a malfunction. (After brief moment, the picture 
will have normal brightness.)

• Adequate ventilation is essential to prevent failure of 

electrical components, we recommend that a gap of at 
least 10 cm is left all around this television receiver even 
when it is placed inside a cabinet or between shelves.

• Avoid exposing the TV set to direct sunlight and other 

sources of heat. To prevent fi re, never place any type 
of candle or naked fl ame on top or near the TV set.

• Ventilation should not be impleded by covering the 

ventilation openings with items such as newspapers, 
table cloths and curtains.

This appliance is supplied with a fi tted three pin mains plug for your safety and convenience. A 5 amp fuse is fi tted in this plug.
If the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.
Check for the ASTA mark 

ASA

 or the BSI mark   on the body of the fuse.

If the fi tted plug has a removable fuse cover you must ensure that it is refi tted when the fuse is replaced. If you lose 
the fuse cover the plug must not be used until a replacement cover is obtained. Replacement fuse covers can be 
purchased through your local Panasonic dealer.

If the fi tted plug is replaced, the fuse should be taken out and the cut off plug disposed of safely. There is 
danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fi tted please observe the wiring code as shown below.
If in any doubt please consult a qualifi ed electrician.

How to replace the fuse (for plug type shown in example 1):
Lift out the removable fuse compartment with a screwdriver and replace the fuse, 
then refi t securely into the mains plug (see example 1).

How to replace the fuse (for plug type shown in example 2):
Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace 
the fuse, then press the fuse cover down securely (see example 2).

IMPORTANT: – The wires in the mains lead of this appliance are coloured in accordance with the following code:–
 

BLUE: NEUTRAL  

BROWN: LIVE

As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the 
terminals in your plug, proceed as follows:–
1. The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.
2. The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.

IMPORTANT NOTE: Under no circumstances should either of these wires be connected to the Earth terminal of   
 

the three pin plug, marked with the letter ‘E’ or the earth symbol 

.

Example 1

Example 2