MGE UPS Systems 2200RT Manual Do Utilizador
Page 14 -
3400753300/AE
5
4
4
7
1. Connect the input power cord 7 to the
AC-power wall-receptacle.
2. Connect the protected equipment to the
UPS. It is advised to connect priority
loads to the outlets and/or power cord 4
and any non-priority loads to the two
programmable outlets 5
loads to the outlets and/or power cord 4
and any non-priority loads to the two
programmable outlets 5
(If the UPS is
connected to a computer running MGE
UPS SYSTEMS, Inc. communication
software, it is possible to program the
interruption of power to the two
programmable outlets 5 during
operation on battery power, thus reserv-
ing backup power for the priority loads).
UPS SYSTEMS, Inc. communication
software, it is possible to program the
interruption of power to the two
programmable outlets 5 during
operation on battery power, thus reserv-
ing backup power for the priority loads).
The battery begins charging the
instant the UPS unit is connected
to a power source. Eight hours are
required to charge to the full rated
backup time.
instant the UPS unit is connected
to a power source. Eight hours are
required to charge to the full rated
backup time.
CAUTION: Check that the indications on the rating plate (on the back of the UPS), correspond to your AC-power
system, and to the actual electrical consumption of all the equipment to be connected to the UPS.
system, and to the actual electrical consumption of all the equipment to be connected to the UPS.
2.6 Connections
2. Installation
5-20P