caddx nx-6 Manual

12

Step 1

Press [

U

]-[0].  Keypad is now in the “Adjust Tone” mode.

Step 2

Pressing  the  [1] key will make the keypad sounder go to higher
tones, pressing the [2] key will make the keypad sounder go to lower
tones.

Step 3

When the desired tone is reached, press the [#] key to set this tone
and exit from the “Adjust Tone” mode.

CHANGE PARTITION – Optional

Step 1

Press [

U

]-[1].

Step 2

Press a NUMBER key (1 or 2) to change partitions momentarily.

Step 3

If no other key is pressed, it will go back to its standard partition in
ten seconds.

Step 4

If another key is pressed, the system will remain in the new partition
until no keys have been pressed for 60 seconds.

Step 1

Press  [

U

]-[3].   The zone(s) that created the last alarm will be

displayed on the keypad.

Step 2

The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed during
the last alarm.

TEST FUNCTION – Optional

If programmed, this function will perform a battery test, communicator test,
and/or a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.

Step 1

Press [

U

]-[4].  The test will be performed as programmed.

Step 2

If the siren test is performed, enter a user code to silence the siren.