caddx nx-6 Manual

5

The 

armed light

 is “on” when the system is armed.  The 

armed light

 is “off”

when it is disarmed.  The 

armed light

 will flash when there has been an alarm

during the previous arm cycle.

The 

bypass light

 is “on” when any zone in this keypad’s partition is bypassed.

The zone(s) that is bypassed will also be illuminated.  If the 

bypass light

 is “off”,

no zones are bypassed.

The 

cancel light

 will flash during an abort delay time.  If a code is entered

followed by the [CANCEL] key while this light is flashing, all abortable reports
will stop the communication process. Note: The abort feature must be
enabled. Entering a code followed by the [CANCEL] key during or after an
alarm report to the central station will cause the 

cancel light

 to come on. It will

stay on until the central station has received the cancel report. Note: The
cancel feature must be enabled.

The c

hime light 

is “on” when the chime feature is “on”;  “off” otherwise.

The 

exit light 

is “on” during the exit delay. Please note that the light will flash

during the last 10 seconds of the exit delay as a warning that the time is
running out.  (The user may want to disarm the system if the 

exit light

 is

flashing in order to prevent an alarm. The user may then re-arm the system
and exit before the delay expires.)

A steady 

fire light

 means a fire zone has been faulted. A rapidly flashing 

fire

light

 means that a fire zone is in a trouble condition.

The 

instant light

 is “on” when there is no delay on your entry/exit door(s). Any

of an entry/exit door will produce an immediate alarm. The 

instant light

 can

be toggled on or off by pressing the [Stay] key while the system is armed.
When the 

instant light

 is “off”, the entry/exit door(s) is delayed.

The 

power light

 is on if the primary power is on. The 

power light

 will flash if the

system has a low battery condition.