Havis-Shields kk-c-st-ss Manual Do Utilizador

KK-C-ST-SS-INST-9-06

SUBASSEMBLY:

1. Bolt floor mounted side brackets to the side bracket supports using the views on the following

page that is vehicle specific. Loosely attach using ¼” x ¾” carriage bolts, flat washers, lock
washers, and hex nuts.

2. Determine height of adjustable frame rail support.

• Hold floor mounted side bracket to the underside of the van floor between the frame and

the fender to determine the height.

• With the specific height determined loosely attach using ¼-20 x 1” hex head bolts

flat

washers, lock washers and hex nuts.

• This will square the backside of the step.

INSTALLATION:

1. PREP THE VAN:

• Pull up carpet along the side door of the van. To do this you must remove the plastic step

well trim piece.

• Locate the center of the side doors and make a visible mark in order to center the side

step.

2. BOLT STEP ASSEMBLY TO VAN:

Note: The frame rail support will not sit flush to frame rail on van.

• Position assembly tight to floor of van with frame rail support tight to frame of van.

Mark and drill (4) ¼” holes through floor of van using holes in floor mounted side
brackets as a template.

Note: side bracket supports may have to be temporarily removed in order to properly position step
between fender and frame rail.

• Position step assembly then loosely reattach side bracket supports.

• Bolt step to floor using ¼-20 x 1” hex head bolts

flat washers, lock washers and hex

nuts.

3. FINAL INSTRUCTIONS:

• Loosen side bracket supports and position tight to fender lip.
• Mark and drill (4) ¼” holes into fender lip using side bracket supports as a template.

• Attach side bracket supports to fender lip using ¼-20 x 1” hex head bolts, flat washers,

lock washers and hex nuts. .

• Check that step slides smoothly and goes to the closed position. Replace carpet and step

sill trim.