Honeywell herculine 2000 Manual Do Utilizador

Set Up and Calibration Procedures 

Set Up Tips 

Revision 7 

  HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 

33 

7/08  

 

 

Table 7 contains tips that will help you view, verify and enter the operating parameters more quickly. If 
you cannot change the parameters, check the status of the “SET LOCK” parameter.  Also some parameters 
require that you enter a security password before you access or change the parameter value.   

 

Use the SET UP key to display and scroll through the set up groups. The 
group titles are listed in the order that they appear on the actuator 
display. 

Use the FUNCTION key to display the individual function parameters 
under each set up group. The prompts are listed in the order of their 
appearance in each group.  See Tables 8 through 19. 

Pressing and holding the SET UP key will scroll through the set up 
groups.  However, when any set up group is displayed, you can scroll 
through the set up groups twice as fast using the

or 

 key. When in 

any set up group, hold the FUNCTION key in to scroll through the 
prompts within that group. 

When changing the value of a parameter, you can adjust a more 
significant digit in the upper display by holding in one key 

 or 

 and 

pressing the other 

 or 

 at the same time. 

• 

The adjustment will move one digit to the left. 

• 

Press the key again and you will move one more digit to the left. 

To exit Set Up mode, press the DISPLAY key.  
This returns the display to the same state it was in immediately preceding 
entry into the Set Up mode. 

If you are in Set Up (configuration) mode and do not press any keys for 
thirty seconds, the actuator display will time out and revert to the mode 
and display that was being used prior to entry into Set Up mode.