Newcon Optik nvs 14 Manual Do Utilizador
19
FIGURE 6
1.
locking screw
2.
flip/flop button
3.
flip-flop adjusting screws
4.
mount binding screw
1
2
3
4
The unit is fixed to the mount by a locking screw (1) (Fig.
6). To adjust the position of the Unit to your eye level use
the screw (4). To adjust the eye relief first loosen locking
screw (1) and set a comfortable distance between the eyes
and the eyepiece; then tighten the locking screw back.
6). To adjust the position of the Unit to your eye level use
the screw (4). To adjust the eye relief first loosen locking
screw (1) and set a comfortable distance between the eyes
and the eyepiece; then tighten the locking screw back.
You can fixate the unit in three predetermined positions: vertical,
horizontal, and 15-20 degrees above horizontal. Although the
relative angles between these positions cannot be changed, the
starting point can be adjusted by screws (3). If you loosen them,
you can rotate the flip-flop mechanism to find the suitable
starting point. Tighten the screws (3) after the adjustment.
horizontal, and 15-20 degrees above horizontal. Although the
relative angles between these positions cannot be changed, the
starting point can be adjusted by screws (3). If you loosen them,
you can rotate the flip-flop mechanism to find the suitable
starting point. Tighten the screws (3) after the adjustment.
You can raise the Unit for unobstructed view without taking the
helmet off. To do so press (and hold) the button (2) and rotate the
helmet off. To do so press (and hold) the button (2) and rotate the