Fujitsu fi-6140 Manual Do Utilizador

fi-6140/

fi-6240 Image Scanner Getting Started

 

AP-1

■ Troubleshooting checklist

Scanner does not turn on.

Have you pressed the power button on?

Push the power button.

Are the AC cable and AC adapter 

properly connected to the 
scanner? 

Correctly connect the AC cable and the AC adapter. 

Disconnect the AC cable and the AC adapter from 
the scanner, then connect them again.

If this does not restore the power supply, contact 

the store where you purchased the scanner or an 
authorized FUJITSU scanner service provider.

Is Windows normally started up?

Push the power button again after completely 

starting up Windows.

Scanning does not start.

Are the documents loaded correctly on the 

ADF paper chute?

Load the document correctly on ADF paper chute.

Is the ADF closed completely?

Close the ADF completely.

Is the USB cable or SCSI cable properly 

connected?

Correctly connect the cable. (When a USB hub is 

used, check the hub's power supply.)

(When using SCSI interface) Is SCSI ID 
set correctly? 

Set SCSI ID correctly by SCSI ID switch on rear of 
scanner.

Does the Function Number Display 

indicates an alarm or an error?

When the Function Number Display indicates an 

alarm or an error, refer to chapter 6 "Troubleshoot-
ing" of "fi-6140/fi-6240 Operator’s Guide" for 

removing the alarm or the error.

Does the alarm state remain displayed 
even after the scanner has been turned off 

and back on again?

Turn off and on the power button.
If this does not eliminate the alarm state, contact the 

store where you purchased the scanner or an 

authorized FUJITSU scanner service provider.