Fujitsu S510 Manual Do Utilizador

 

22  

 

 

This chapter describes how to clean the ScanSnap. 

●  Before cleaning the scanner, disconnect the AC 

adapter from the power outlet. 

●  Do not use any aerosol sprays or alcohol based sprays 

to clean the scanner. 

Dust blown up by strong air from the spray may enter 

the inside of the scanner. This may cause the scanner 

to fail or malfunction, or errors in scanned images. 

Sparks, caused by static electricity, generated when 

blowing off dust and dirt from the outside of the 

scanner may cause a fire. 

5.1. Cleaning Materials 

Cleaning Materials 

Parts No. 

Remarks 

Cleaner F1

PA03950-0352 

1 bottle (100ml)    (*1)

Cleaning wipe 

PA03950-0419 

1 pack (24 sheets)   
(*1) (*2) 

*1) To purchase the cleaning material, contact the store where you 

purchased the scanner or an authorized FUJITSU scanner service 
provider.  

*2) Pre-moistened with Cleaner F1, Cleaning Wipes are used instead of 

moistened cloths. 

Clean the scanner exterior with a cloth moistened with a 
small amount of neutral detergent or Cleaner F1 (sold 
separately). 

 

● 

Never use paint thinner or other organic 

solvents.

 

● 

During the cleaning, prevent water or 

moisture from getting inside the scanner.

 

● 

It may take long before the cleaner 

vaporizes if a large quantity is used. When 

cleaning the scanner parts, dampen a 

cloth with modest quantities of the 

cleaner. In addition, wipe off the cleaner 

completely with a soft lint-free cloth to 

leave no residue on the surface of the 

cleaned parts. 

 

Clean inside of the scanner with a cloth moistened with 
Cleaner F1. 
In an alternating succession of scanning documents, the 
accumulated paper-powder and dust inside the scanner 
causes a scanning error. 
As a guideline, clean the ADF every 1,000 scans. Note that 
this guideline varies according to the type of documents 
you are scanning. For example, the ADF must be cleaned 
more frequently when scanning documents on that the 
toner has not been sufficiently fixed on. 
Clean the ADF according to the following procedure 
referring to the illustrations. 
 

 

The glass surface inside the ADF becomes hot during 
the scanner operation. 
Before you start cleaning the inside of the scanner, 
disconnect the AC adapter from the outlet, and wait at 
least 15 minutes to let the scanner cool down. 
 

CAUTION

 

When you perform cleaning, make sure that the inside of 
the scanner is free of any foreign object, and be careful 
not to get your hand or the cloth caught on the pick 
spring (metal part) as a deformed pick spring (metal 
part) may cause injury. 
 

● 

Never use water or neutral detergent to 
clean the inside of the scanner.

 

● 

It may take long before the cleaner 
vaporizes if a large quantity is used. When 
cleaning the scanner parts, dampen a 
cloth with modest quantities of the 
cleaner. In addition, wipe off the cleaner 
completely with a soft lint-free cloth to 
leave no residue on the surface of the 
cleaned parts.

 

1.  Open the ADF while pulling the Cover open lever.   

 

Cloth 

Neutral detergent 
or Cleaner F1 

Paint thinner 

Cover open lever 

ADF