Fujitsu S510 Manual Do Utilizador

 

6  

 

This chapter describes necessary preparations before using 
ScanSnap. 

 

Do not connect the scanner to your PC 
before installing "ScanSnap Manager". 
If the scanner is connected before installing 
ScanSnap Manager, it will not operate 
correctly. 
Refer to Chapter 2 for the installation of 
ScanSnap Manager.

 

When you unpack the scanner package, make sure that all 
parts are included. 
Refer to the package contents list included in the scanner 
package box. 

This section describes the names and functions of parts. 

 

Front View   

 

 

 

 

 

HINT

For the Document Specification, refer to the 
“ScanSnap S510 Operator’s Guide” stored in 
ScanSnap Setup CD-ROM.   

 

 

The scanner is turned on/off automatically, when 
you open/close the Paper chute cover. 
To turn off the scanner when the cover is opened, 
press the [POWER] button. 

 

[SCAN] button 
Starts scanning. 

[POWER] button 
Turns on/off the power supply. 

Power Indicator 

 

Indicates the scanner status of 
the power supply to the 
scanner. 
Blue (Solid): Ready 
Blue (Blinking):   Scanning 
Orange: Error 
Light off: Power 

off 

SCAN

POWER

Seal (reminds you that the 
supplied software has to be 
installed first): After installing 
ScanSnap Manager onto your 
computer, remove this seal to connect 
the scanner to the PC. 

Security cable slot
Plug a commercially 
available security cable 
into this slot (anti-theft)

 

Paper chute 
Open this cover when using 
the scanner. 

 Opening the cover turns ON 

the scanner. 

 

Cover open lever 
Pull this lever to open the ADF cover. 

Open it and load the documents onto this 

part when scanning documents. 

Side guide 
Adjust these guides to the documents 
width for preventing skewed   

ADF 
(ADF: Automatic Document  
Feeder) 

Stacker 
For using this part, pull it out   
as shown in the figure. 

 Documents are ejected from the ADF onto this tray.