Fujitsu m3099ex-eh Manual Do Utilizador

M3099EX/EH OEM Manual

B-10

<< SETUP MODE >>

RS232C BAUD

<< SETUP MODE >>

9600 : 4800 : 2400 : 1200

When you reset the number to the initial number, you must see Section
A2.4 of Appendix A.

When you reset the ink counter, you must see Section A2.5 of Appendix A.

When you set the RS232C transfer rate, you must set as follows.

#1 At Screen 2, press [Mode 1] twelve tmies to

go to the RS232C BAUD screen. (Screen 23)

#2 Press [Mode 2] to see Screen 24. (The default

setting is 4800 bpsi)

#3 At Screen 24, press [Mode 1] until the value

you want to change blinks.

#4 Press [Mode 2] to see Screen 23. The settings

are stored to EEPROM.

#5 When you close the setup mode, go to 9.

When you set the picking start time, you must set as follows.

#6 At Screen 2, press [Mode 1] thirteen times to

go to the PICK START TIME screen.
(Screen 25)

#7 Press [Mode 2] to see Screen 26. (The default

setting is 1 sec.)

#8 At Screen 26, press [Mode 1] until the digit

you want to change blinks. Then press [Mode
2] until the digit changes as you want. (The
specifiable range is from 0.2 to 29.8 sec. in
0.2 sec. step.)

Screen 23

Screen 24

<< SETUP MODE >>

PICK START TIMER

PICK START TIMER

X X . X

S

Screen 26

Screen 25