eutech-instruments cyberscan con 10 conductivitytds meter Manual Do Utilizador

8

Your meter comes complete with an electrode holder. It is designed for easy use and

installation. Care must always be taken to avoid use of excessive force in the process of

attaching these components.

a) 

Align the end of the electrode (sensor side) with the hole of the holder. Note that the top

side of the holder is where the slot begins.

b) 

Always ensure that the diameter of the electrode you intend to use is 12 mm. Otherwise,

the electrode may not fit properly.

c) 

Insert the electrode into the hole of the holder until the top housing of electrode touches

the top of the holder. Remember not to force the electrode into the holder.

The CyberScan CON 10/100/200 meter has the flexibility of operating from an A.C. power

source. This is extremely useful if you have an A.C. source available near the meter (e.g.

Laboratory).

1. 

Before plugging in the A.C. adapter, switch off the meter and the power source of the

A.C. adapter. This is a safety precaution that should be adhered to safeguard your meter.

2. 

The A.C. adapter should have the following settings:

Output Voltage: 9 V D.C.

Current:  500 mA

3. 

Insert the D.C. jack into the socket of the meter as shown in Figure 9.

4. 

Switch on the power to the adapter, followed by the meter.