Eclair ACL II Manual Do Utilizador

If you must replace your motor, please

proceed as follows

• Disconnect the battery from the camera before
this operation is carried out.
• Take the lens off the camera.
• Turn the knurled knob 31 to bring the reflex
mirror in the aperture centre. In this position the
screw 46 of the knurled knob 31 of the motor is
adjacent to the guide mark     engraved on the
motor casing - fig IK -; this position vertically the
two driving spigots 42 of the motor - fig JIL - and
the two corresponding holes of the camera rubber
driver (41) - fig KM -.
• Undo the three captive screws (40) with a screw-
driver or a coin and pull the motor out along its
drive axis.

NOTE. For checking purpose, the bottom

screw (40) is sealed. Take the seal off with a small
screwdriver or a small pointed tool to allow access
to the screw.

• Make sure that the screw 46 of the knurled knob
31 is perfectly in line with the guide Q mar and
that the ref lex mirror is in the centre of the aper-
ture.

Align the camera plug (44) on the motor

with its socket (45) on the camera and push the
motor into place along its drive axis - fig JL and
KM-. The two drive spigots (42) on the motor
must be perfectly in place in the two holes of
the camera rubber driver 41.
• Tighten the three screws 40.
• Check that the drive is correctly engaged by
turning the knurled knob (31) anti-clockwise. It
should run ireely.
• Re-connect the battery.

30

Fig. IK

46 31

47 38 35

46

38 47

44

42

43

Fig. JL

Fig. KM

45

41