Hitachi CP-A300NM Manual Do Utilizador

43

SETUP menu

Using the ◄/► buttons corrects the horizontal keystone distortion.

Shrink the right of the image Ù Shrink the left of the image

• The adjustable range of this function will vary among inputs. For 

some input, this function may not work well.

• This function will be unavailable when the Transition Detector is on 

( 74) or the PERFECT FIT ( 43) is adjusted.

This item allows you to adjust the shape of the projected image in

each of the corners and sides.

(1) Choose a corner or side to adjust 

using the ▲/▼/◄/► buttons and press 

the ENTER or INPUT button.

(2) Adjust the distortion as below. Use 

the ▲/▼/◄/► buttons to adjust the 

position of the corner. Use the ▲/▼ 

buttons to adjust the distortion of the 

top or bottom side, after dening the 

adjusting position with the ◄/► buttons.

Use the ◄/► buttons to adjust the distortion of the left or right side, 

after dening the adjusting position with the ▲/▼ buttons.

(3) To adjust another corner or side, follow the same procedure

from (1) above. To reset the adjustment of all the corners and sides, 

select RESET with the ▲/▼ buttons and press the ENTER or 
INPUT

 button.

• While the distortion is adjusted with the PERFECT FIT function, 

keystone adjustment feature is unavailable. To correct the keystone 

distortion, reset the adjustment of all the corners and sides.

• The adjustable range of this correction will vary among inputs. For 

some input, this function may not work well.

• One adjustment position common to the top and bottom sides can 

be set. Also, another adjustment position common to the left and 

right sides can be set.

• The distortion of the top and bottom sides can be adjusted only in 

the same direction, pincushion or barrel. The adjustment for the left 

and right sides is carried out in the same manner.

• This function will be unavailable when the Transition Detector is on 

( 74).

Using the ▲/▼ buttons turns on/off the AUTO ECO MODE.

ON Ù OFF

•

 

When ON is selected, the projector will always be set to Eco mode 

at start-up regardless of the ECO MODE 

( 44) setting. An OSD 

message “AUTO ECO MODE” will be displayed for tens of seconds 

when the projector starts with this function activated.

(continued on next page)