AudioControl Epicenter® 1200 Manual Do Proprietário

Installation Manual

1.  Ensure that the two M3 x 10 mm screws on the straight edge of 

the lid are present and backed out a tad until the front edge of 
the screws are flush with the threads in the lid. If you have lost 
them (tut-tut), then use only M3 x 10 mm screws and no longer 
than that.

2.  Align the wavy edge of the lid along the heatsink fins, and lower 

the straight edge of the lid to 2” above the surface of the amplifi-
er.

3.   Slide the lid towards the connectors, engaging the top two 

points of contact under the wavy edge of the lid.

4.  Lower the lid flat onto the surface of the amplifier.

5.  Secure the two M3 x 10 mm screws near the connectors using 

the 2.5 mm hex key*

* If your school metalwork teacher was a 6’5” rugged giant of a man, an ex-Royal Marine Com-
mando called Tiny, and he insisted that these be called hexagonal wrenches and not hex keys or 
Allen Keys, then so be it.

The top lid must be removed to gain access to the controls, and then 
put back on again to protect the controls from dust bunnies, food 
crumbs, and other dirt and grime.

1.  Locate the two M3 x 10 mm screws that hold the straight edge 

of the lid onto the connector side of the amplifier. 

2.  Use the supplied 2.5 mm hex key to loosen both screws just 

enough until this edge of the lid can lift freely up just a little. 
(There is no need to remove the screws all the way, in case you 
lose them.)

3.  Slide the lid toward the heatsink fins just a tad, before further 

lifting the straight edge of the lid about 2”, then disengage the 
remaining two points of contact (under the wavy edge).

4.  Place the lid in a safe and handy place, ready for the time when 

you have finished adjusting the controls to your immense satis-
faction.

Chapter 4: Installation