ResMed AIR103G Manual Do Utilizador

• Supplemental oxygen must not be used while smoking or in the presence of an open

flame.

• Always make sure that the device is turned on and airflow generated before the oxygen

supply is turned on. Always turn the oxygen supply off before the device is turned off, so

that unused oxygen does not accumulate within the device enclosure and create a risk of

fire.

• Do not perform any maintenance tasks while the device is in operation.

CAUTION

• Use only ResMed parts and accessories with the device. Non-ResMed parts may reduce the

effectiveness of the treatment and/or damage the device.

• Use only vented masks recommended by ResMed or by the prescribing doctor with this

device. Fitting the mask without the device blowing air can result in rebreathing of exhaled

air. Make sure that the mask vent holes are kept clear and unblocked to maintain the flow

of the fresh air into the mask.

• Be careful not to place the device where it can be bumped or where someone is likely to

trip over the power cord.

• Blocking the air tubing and/or air inlet of the device while in operation could lead to

overheating of the device.

• Keep the area around the device dry, clean and clear of anything (eg, clothes or bedding)

that could block the air inlet or cover the power supply unit.

• Do not place the device on its side as water might get into the device.
• Incorrect system setup may result in incorrect mask pressure reading. Ensure the system is

correctly set up.

• Do not use bleach, chlorine, alcohol, or aromatic-based solutions, moisturizing or

antibacterial soaps or scented oils to clean the device, the water tub or air tubing. These

solutions may cause damage or affect the humidifier performance and reduce the life of

the products.

• If you use the humidifier, always place the device on a level surface lower than your head

to prevent the mask and air tubing from filling with water.

• Leave the water tub to cool for ten minutes before handling to allow the water to cool and

to make sure that the water tub is not too hot to touch.

• Make sure that the water tub is empty before transporting the device.

Technical specifications

90W power supply unit
AC input range:

100–240V, 50–60Hz 1.0–1.5A, Class II

115V, 400Hz 1.5A, Class II (nominal for aircraft use)

DC output:

24V

3.75A

Typical power consumption:

53W (57VA)

Peak power consumption:

104W (108VA)

Environmental conditions

Operating temperature:

+41°F to +95°F (+5°C to +35°C)

Note: The air flow for breathing produced by this therapy

device can be higher than the temperature of the room.

Under extreme ambient temperature conditions

(104°F/40°C) the device remains safe.

Operating humidity:

10 to 95% relative humidity, non-condensing

Operating altitude:

Sea level to 8,500' (2,591 m); air pressure range 1013 hPa to

738 hPa

Storage and transport temperature:

-4°F to +140°F (-20°C to +60°C)

Storage and transport humidity:

5 to 95% relative humidity, non-condensing

English