Roseman Engineering Ltd. 2288 Manual Do Utilizador
998 Old Eagle School Road, Suite 1215
|
Wayne, Pennsylvania 19087
|
T: 610-225-8350
|
F: 610.971.9447
|
www.assetworks.com
10
3
FJ3 Installation
Mount the FJ3
1. After reviewing the recommendations listed in 2.1 “ Installation Installation Considerations”,
mount the FJ3 as follows:
•
If possible, mount it on the same side of the vehicle as the filler neck.
•
For a passenger car, the FJ3 can be mounted under the dashboard or in the
trunk, provided that the unit is at least 3 feet from the filler neck.
trunk, provided that the unit is at least 3 feet from the filler neck.
•
For a truck or bus, the FJ3 can be mounted inside the vehicle's electric
enclosure.
enclosure.
2. Drill at least two 1/8" holes for the FJ3 mounting. Use the FJ3 to mark the holes (see Figure 2:
FJ3 Wiring Diagram)
3.
4. Figure 2 shows the FJ3 mounted on the vehicle chassis, or any other metal portion of the vehicle
4. Figure 2 shows the FJ3 mounted on the vehicle chassis, or any other metal portion of the vehicle
whenever possible.
Do not use an electric drill or any other electrical power tool
within 3 feet of the filler neck or fuel tank. This area is
considered a Class I Group D hazardous location.
within 3 feet of the filler neck or fuel tank. This area is
considered a Class I Group D hazardous location.
5. Using the two 3/8" self-tapping mounting screws and two lock washers, mount the FJ3 to the
vehicle frame. You must use two self-tapping sheet metal screws.