Roseman Engineering Ltd. 2288 Manual Do Utilizador
998 Old Eagle School Road, Suite 1215
|
Wayne, Pennsylvania 19087
|
T: 610-225-8350
|
F: 610.971.9447
|
www.assetworks.com
7
Required Tools
The following tools are required to complete the installation procedures:
•
Screwdrivers
•
Box wrenches
•
Crimping tool
•
Wire stripping tool
•
Drill with 1/8" drill bit
•
Heat gun (for heat-shrink insulation)
Required Materials
The following materials are required to complete the installation procedures:
•
Two conductor twisted pair cable – 20 - 22 AWG with foil shield and drain wire
•
Wire terminals. Do not use Scotch Locks.
•
3/8" inch self-tapping, sheet metal screws (Rittal SZ2487 or equivalent) with
matching flat washers and split washers
matching flat washers and split washers
•
Grommets
•
Three amp fuse and fuse holder
•
Wire ties, wire solder and wire loom
•
Heat shrink tubing
•
Butt connectors for 20 - 22 AWG wire
Wiring Instructions
The general procedures for wiring the FJ3 are as follows:
•
Using a wire stripping tool, remove insulation to bare 3/8" of wire.
•
Press firmly on the connector locking tab.
•
Insert the exposed wire end.
•
Release the locking tab.
•
Check to make certain the wire is held firmly in place and that the wire insulation
is not pinched in the terminal.
is not pinched in the terminal.
Use gasoline and oil-resistant wiring only. Route wires away
from moving parts and the vehicle’s exhaust system.
from moving parts and the vehicle’s exhaust system.