Brodit ProClip 513248 513248 Folheto
Códigos do produto
513248
1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape
provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does
not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located
in a position within easy reach of any GPS or charging adapters.
Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1.
Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the
Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
How to mount the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel
attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into
place with the enclosed screws. 2. Place the holder over the attaching plate so the screw fits in the hole in the tilt
swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it
slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw
firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted. 3. Slide the device
sideways into the holder until you her / feel it snaps into place. 4. The holder is in place.
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape
provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does
not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located
in a position within easy reach of any GPS or charging adapters.
Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1.
Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the
Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.
How to mount the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel
attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into
place with the enclosed screws. 2. Place the holder over the attaching plate so the screw fits in the hole in the tilt
swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it
slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw
firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted. 3. Slide the device
sideways into the holder until you her / feel it snaps into place. 4. The holder is in place.
2 (2)