TP-LINK CPE510 Manual Do Utilizador
Chapter 5 Network Tab
WAN
NOTE:
WAN submenu is only available on AP router mode and AP client router (WISP Client) mode.
There are five WAN connection types: Static, Dynamic, PPPoE, L2TP, and PPTP. Select the suitable one to
configure the IP parameters of the WAN on the screen below. If you are not sure of the connection type to
use, please consult your ISP.
configure the IP parameters of the WAN on the screen below. If you are not sure of the connection type to
use, please consult your ISP.
Static
This connection type uses a permanent, fixed (static) IP address that your ISP assigned. In this type, you
should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually, which are specified by
your ISP.
should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually, which are specified by
your ISP.
IP Address
Enter the IP address provided by your ISP.
Netmask
Enter the Netmask provided by your ISP. Normally use 255.255.255.0 as the
netmask.
netmask.
Gateway IP
Enter the gateway IP address provided by your ISP.
Primary DNS
Enter the DNS IP address provided by your ISP.
- 38 -