Nxp Semiconductors LPC2194HBD64,151 ARM7 Microcontroller 16kB LQFP 64 LPC2194HBD64,151 Ficha De Dados
Códigos do produto
LPC2194HBD64,151
1.
General description
The LPC2194 is based on a 16/32-bit ARM7TDMI-S CPU with real-time emulation and
embedded trace support, together with 256 kB of embedded high-speed flash memory. A
128-bit wide memory interface and a unique accelerator architecture enable 32-bit code
execution at maximum clock rate. For critical code size applications, the alternative 16-bit
Thumb mode reduces code by more than 30 % with minimal performance penalty.
embedded trace support, together with 256 kB of embedded high-speed flash memory. A
128-bit wide memory interface and a unique accelerator architecture enable 32-bit code
execution at maximum clock rate. For critical code size applications, the alternative 16-bit
Thumb mode reduces code by more than 30 % with minimal performance penalty.
With its compact 64-pin package, low power consumption, various 32-bit timers,
4-channel 10-bit ADC, four advanced CAN channels, PWM channels and 46 GPIO lines
with up to nine external interrupt pins this microcontroller is particularly suitable for
automotive applications such as a CAN gateway that connects several CAN busses or a
CAN bridge between sub networks at different speeds. Sensors with CAN interface or
debugging via CAN are additional applications that need more than two CAN interfaces. It
is also an adequate solution for industrial control, medical systems and fault-tolerant
maintenance buses. With a wide range of additional serial communications interfaces, it is
also suited for communication gateways and protocol converters as well as many other
general-purpose applications.
4-channel 10-bit ADC, four advanced CAN channels, PWM channels and 46 GPIO lines
with up to nine external interrupt pins this microcontroller is particularly suitable for
automotive applications such as a CAN gateway that connects several CAN busses or a
CAN bridge between sub networks at different speeds. Sensors with CAN interface or
debugging via CAN are additional applications that need more than two CAN interfaces. It
is also an adequate solution for industrial control, medical systems and fault-tolerant
maintenance buses. With a wide range of additional serial communications interfaces, it is
also suited for communication gateways and protocol converters as well as many other
general-purpose applications.
Remark: Throughout the data sheet, the term LPC2194 will apply to devices with and
without the /00 suffix. New devices will use the /00 suffix to differentiate from the original
devices only when necessary.
without the /00 suffix. New devices will use the /00 suffix to differentiate from the original
devices only when necessary.
2.
Features
2.1 Key features
16/32-bit ARM7TDMI-S microcontroller in a tiny LQFP64 package.
16 kB on-chip Static RAM and 256 kB on-chip flash program memory. 128-bit wide
interface/accelerator enables high speed 60 MHz operation.
interface/accelerator enables high speed 60 MHz operation.
In-System Programming (ISP) and In-Application Programming (IAP) via on-chip
bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or
full chip erase takes 400 ms.
bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or
full chip erase takes 400 ms.
EmbeddedICE-RT and Embedded Trace interfaces offer real-time debugging with
on-chip RealMonitor software as well as high speed real-time tracing of instruction
execution.
on-chip RealMonitor software as well as high speed real-time tracing of instruction
execution.
Four interconnected CAN interfaces with advanced acceptance filters. Additional serial
interfaces are two UARTs (16C550), Fast I
interfaces are two UARTs (16C550), Fast I
2
C-bus (400 kbit/s) and two SPIs.
Four channel 10-bit ADC with conversion time as low as 2.44
µs.
Two 32-bit timers (with four capture and four compare channels), PWM unit (six
outputs), Real-Time Clock and Watchdog.
outputs), Real-Time Clock and Watchdog.
LPC2194
Single-chip 16/32-bit microcontroller; 256 kB ISP/IAP flash
with 10-bit ADC and CAN
with 10-bit ADC and CAN
Rev. 04 — 11 September 2006
Product data sheet